LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Sensor And/Or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
    2. Fig 1: Oil Pressure Sensor Electrical Connector
    GM3635152Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the engine harness electrical connector (1) from the oil pressure sensor.
    3. Fig 2: Oil Pressure Sensor And Washer
    GM3635156Courtesy of GENERAL MOTORS COMPANY
  3. If not equipped with active fuel management perform the following step, using J 41712  oil pressure switch socket or equivalent, remove the oil pressure sensor (1) and washer (2).
    4. Fig 3: Oil Pressure Sensor, Washer, Filter And Seal
    GM3635161Courtesy of GENERAL MOTORS COMPANY
  4. If equipped with active fuel management perform the following step, using J 41712  oil pressure switch socket or equivalent, remove the oil pressure sensor (1) and washer (2).
    1. Remove and discard oil pressure sensor filter (3).
    2. Inspect seal (4) for damage. Replace if necessary.
scientia non olet · About LEMON Manuals