LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drive Belt Idler Pulley
    GM678804Courtesy of GENERAL MOTORS COMPANY
  1. Position the drive belt idler pulley to the generator bracket and tighten the idler pulley bolt finger tight.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Tighten the drive belt idler pulley bolt.

    Tighten 

    Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals