LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Camshaft Position Actuator Magnet Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: CMP Actuator Magnet, Bolts And Gasket
    GM3633647Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The gasket surface should be free of oil or other foreign material during assembly.

  1. Install a NEW CMP actuator magnet gasket (3) onto the CMP actuator magnet.
  2. Install the CMP actuator magnet (2) to the front cover.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the CMP actuator magnet bolts (1) and tighten to 10 N.m (89 lb in).
  4. Connect the engine harness electrical connector to the CMP actuator magnet.
  5. Install the water pump. Refer to Water Pump Replacement (L96) .
scientia non olet · About LEMON Manuals