LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Flywheel And Bolts
    GM832979Courtesy of GENERAL MOTORS COMPANY
  1. Remove the automatic transmission. Refer to Transmission Replacement .
    2. NOTE:

    Note the position and direction of the engine flywheel before removal.

  2. Remove the flywheel bolts.
  3. Remove the flywheel.
    4. Fig 2: Bolts And Spacer
    GM642281Courtesy of GENERAL MOTORS COMPANY
  4. Install two M11 x 1.5 mm bolts (1) to the threaded holes of the spacer, if applicable.
  5. Rotate the bolts clockwise to remove the spacer.
    6. Fig 3: Crankshaft Spacer
    GM642276Courtesy of GENERAL MOTORS COMPANY
  6. Remove the spacer from the rear of the crankshaft, if applicable.
scientia non olet · About LEMON Manuals