LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - Off Vehicle >> Oil Pan Removal

Oil Pan Removal

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Left Closeout Cover And Bolt
    GM178477Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:
    • The original oil pan gasket is retained and aligned to the oil pan by rivets. When installing a new gasket, it is not necessary to install new oil pan gasket rivets.
    • DO NOT use the oil pan gasket again. When installing the oil pan, install a NEW oil pan gasket.
    • It is not necessary to remove the oil level indicator switch prior to oil pan removal. Remove the oil level indicator switch, if applicable and if service is required.
  1. Remove the left closeout cover and bolt.
    2. Fig 2: Right Closeout Cover And Bolt
    GM178480Courtesy of GENERAL MOTORS COMPANY
  2. Remove the right closeout cover and bolt.
    3. Fig 3: Oil Indicator Switch
    GM260123Courtesy of GENERAL MOTORS COMPANY
  3. Remove the oil indicator switch from the oil pan, if applicable and if service is required.
    4. Fig 4: Oil Pan
    GM260108Courtesy of GENERAL MOTORS COMPANY
  4. Remove the oil pan bolts.
  5. Remove the oil pan.
    6. Fig 5: Drilling Out Oil Pan Gasket Retaining Rivets
    GM1272840Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:
    • DO NOT allow foreign material to enter the oil passages of the oil pan. Cap or cover the openings, as required.
    • Use care not to gouge, score, or damage the oil pan sealing surface.
  6. Drill (2) out the oil pan gasket retaining rivets (1), if required.
  7. Remove the gasket (426) from the pan.
  8. Discard the gasket and rivets.
scientia non olet · About LEMON Manuals