Engine Block Valley Cover Installation
WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the O-ring seals with clean engine oil.
- Install the O-ring seals (537) to the cover (555).
- Install the cover (555), gasket (556), and bolts (506). Tighten the manifold bolts to 25 N.m (18 lb ft).
- Apply sealant to the threads of the sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers
- Install the oil pressure sensor (706) and sealing washer (707). Tighten the sensor to 35 N.m (26 lb ft).
NOTE:
All gasket surfaces should be free of oil or other foreign material during assembly.
CAUTION:
Refer to Fastener Caution .