LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - Off Vehicle >> Cylinder Head Removal - Left Side

Cylinder Head Removal - Left Side

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cylinder Head And Bolts (Left Side)
    GM1658150Courtesy of GENERAL MOTORS COMPANY
  1. If camshaft lobe lift measurement is required, perform measurement prior to removal of the cylinder heads. Refer to Camshaft and Bearings Cleaning and Inspection .
    2. NOTE:

    The cylinder head bolts are of a torque-to-yield design and are NOT to be used again. Install NEW cylinder head bolts during assembly.

  2. Remove the cylinder head bolts (220, 221).
    3. CAUTION:

    After removal, place the cylinder head on 2 wood blocks in order to prevent damage to the sealing surfaces.

  3. Remove the cylinder head (218).
    4. Fig 2: Cylinder Head Gasket And Locating Pins
    GM1658153Courtesy of GENERAL MOTORS COMPANY
  4. Remove the gasket (217) and locating pins (230).
  5. Discard the gasket and cylinder head bolts.
scientia non olet · About LEMON Manuals