LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - Off Vehicle >> Crankshaft Rear Oil Seal Housing Cleaning And Inspection

Crankshaft Rear Oil Seal Housing Cleaning And Inspection

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft Rear Oil Seal And Housing
    GM1552461Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Do not use the crankshaft rear oil seal again. Install a NEW crankshaft oil seal during assembly.
    • Do not use the rear housing-to-engine block gasket again. Install a NEW gasket during assembly.
  1. Remove the crankshaft oil seal (141) from the rear housing.
  2. Clean the housing in solvent. Remove the sealant from the housing oil pan surface. Refer to Replacing Engine Gaskets .
    3. WARNING:

    Refer to Safety Glasses Warning .

  3. Dry the housing with compressed air.
  4. Inspect the gasket sealing surfaces for excessive scratches or gouging.
  5. Inspect the housing-to-oil pan threaded bolt holes for damaged threads or debris.
  6. Inspect the crankshaft oil seal mounting bore for damage.
scientia non olet · About LEMON Manuals