LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 6L80 (MYC) Or 6L90 (MYD) - Diagnostic Information And Procedures) >> Diagnostic Information And Procedures >> Harsh, Soft, Delayed Or Slipping Second Or Sixth Gear

Harsh, Soft, Delayed Or Slipping Second Or Sixth Gear

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban 3500 HD, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
Checks Causes
NOTE:

On cold days, approximately 32°F (0°C) or colder, the transmission is designed to shift differently. The transmission uses a warm-up mode shift schedule until the engine reaches normal operating temperature. While the transmission is in warm-up mode, it is normal for transmission upshifts to be delayed or held longer. This feature improves heater performance by giving quicker vehicle warm-ups.

A/Trans Fluid Pan Assembly (29) Verify proper fluid level and condition, inspect transmission assembly for leaks.
Control Valve Upper Body Assembly (304)
  • Inspect for sticking, damaged or worn 2-6 clutch regulator valve (334) and spring (326).
  • Inspect for damaged or sticking #6 ball check valve.
Control Solenoid (w/Body and TCM) Valve Assembly (314)
Center (with 2-6 Low and Reverse Clutch) Support Assembly (67)
  • Inspect for proper installation of the 2-6 clutch return spring retaining ring (455).
  • Inspect for damaged 2-6 clutch piston assembly (457), spring (456), retaining ring (455), and center support assembly (459).
  • Inspect for worn or damaged 2-6 clutch plates (451 - 453).
A/Trans Fluid Pump Cover Assembly (219)
  • Inspect for damaged, stuck, sticky pressure regulator valve (233) and springs (234 and 235).
  • Inspect for damaged, stuck, sticky isolator valve (236) and sleeve (237).
Center Support Fluid Passage Seal Assembly (20)
  • Inspect for worn, cut, or damaged seals.
  • Inspect for proper seal (20) size (6L45/50E MYA/MYB) vs (6L80/90E MYC/MYD).