LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 6L80 (MYC) Or 6L90 (MYD) - Diagnostic Information And Procedures) >> Diagnostic Information And Procedures >> DTC P0815, P0816, P0826, Or P1876: Switch Circuit >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban 3500 HD, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, place the S3 Transmission Shift Lever in manual mode range position.
  2. Verify with a scan tool, the Driver Shift Control Mode parameter displays Active.
    • If the parameter does not display Active 

      Refer to Circuit/System Testing.

    • Go to next step: If the parameter does display Active 
  3. Verify with a scan tool, the Driver Shift Request parameter displays Upshift, when momentarily pressing the plus (+) switch.
    • If the parameter does not display Upshift 

      Refer to Circuit/System Testing.

    • Go to next step: If the parameter does display Upshift 
  4. Verify with a scan tool, the Driver Shift Request parameter displays Downshift, when momentarily pressing the minus (-) switch.
    • If the parameter does not display Downshift 

      Refer to Circuit/System Testing.

    • Go to next step: If the parameter does display Downshift 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observe from the Freeze Frame/Failure records data.
  6. Verify the DTC does set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • Go to next step: If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals