LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 6L80 (MYC) Or 6L90 (MYD) - Diagnostic Information And Procedures) >> Diagnostic Information And Procedures >> DTC P0741 Or P0742: Torque Converter Clutch (TCC) System >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban 3500 HD, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    If other DTCs are set, diagnose those DTCs first.

  1. Engine idling in Park position, with parking brake applied and drive wheels chocked.
  2. Verify the transmission fluid level and condition is correct. Refer to Transmission Fluid Level and Condition Check .
    • If the transmission fluid level and condition is not correct 

      Repair as necessary.

    • Go to next step: If the transmission fluid level and condition is correct 
  3. Ignition ON, clear the Transmission Control Module DTCs with a scan tool.
    4. NOTE:

    During the road test, the Transmission Control Module must see 2 attempts at Torque Converter lockup.

  4. Verify the transmission operation performs as indicated in the road test instructions and DTCs P0741 or P0742 did not set. Refer to Road Test .
    • If DTC P0741 or P0742 set 

      Refer to Circuit/System Testing.

    • Go to next step: If DTC P0741 or P0742 did not set 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observe from the Freeze Frame/Failure Records data.
  6. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • Go to next step: If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals