LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 6L80 (MYC) Or 6L90 (MYD) - Diagnostic Information And Procedures) >> Diagnostic Information And Procedures >> DTC P06AC, P06AD, Or P06AE: Control Module Power Up Temperature Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban 3500 HD, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, clear the DTCs with a scan tool.
  2. Operate the vehicle at 64 km/h (40 mph) for 10 min.
  3. Verify DTC P06AC, P06AD or P06AE is not set.
    • If any of the DTCs set 

      Replace the Q8 Control Solenoid Valve Assembly.

    • Go to next step: If none of the DTCs set 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observe from the Freeze Frame/Failure Records data.
  5. Verify the DTC does not set.
    • If the DTC sets 

      Replace the Q8 Control Solenoid Valve Assembly.

    • Go to next step: If the DTC does not set 
  6. All OK.
scientia non olet · About LEMON Manuals