LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Transfer Case - Mp 3010 (NP0)) >> Repair Instructions - On Vehicle >> Front Output Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  3. Remove the front propeller shaft. Refer to Front Axle Propeller Shaft Replacement (NQH)Front Axle Propeller Shaft Replacement (Heavy Duty) .
  4. Insert a screwdriver between the metal inner and metal outer portions of the seal.
    Fig 1: Front Output Shaft Slinger And Oil Seal
    GM2716860Courtesy of GENERAL MOTORS COMPANY
    NOTE: Remove the front output shaft seal in two pieces using the following procedure.
  5. Pry upward in multiple locations working the metal inner portion of the seal off the shaft until removed.
  6. Once the inner metal portion is removed, insert a screwdriver between the outer diameter metal flange of the seal and the housing.
  7. Drive the screwdriver inward in multiple locations, the outer portion of the seal will be distorted and can easily be removed from the housing.
scientia non olet · About LEMON Manuals