LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Transfer Case - Mp 3010 (NP0)) >> Repair Instructions - On Vehicle >> Front Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the J-8092  driver handle and DT-50649  installer (2) install the front output shaft oil seal (1) to the transfer case.
    Fig 1: Front Output Shaft Oil Seal And Installer
    GM2716858Courtesy of GENERAL MOTORS COMPANY
  2. Using the J-8092  driver handle and DT-50649  installer (2) install the front output shaft oil slinger (1) to the transfer case.
    Fig 2: Front Output Shaft Oil Slinger And Installer
    GM2716856Courtesy of GENERAL MOTORS COMPANY
    NOTE: The new design front output shaft oil slinger can be installed onto all current and prior model year applications, providing the new design front output shaft seal is also installed. Refer to Transfer Case Description and Operation .
  3. Install the front propeller shaft. Refer to Front Axle Propeller Shaft Replacement (NQH)Front Axle Propeller Shaft Replacement (Heavy Duty) .
  4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals