Rear Output Shaft Seal and Bushing Removal

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Transfer Case Rear Output Shaft Seal & Bushing

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Transfer Case Rear Output Shaft Seal CAUTION: Refer to Transfer Case Seal Removal Caution .
2	Transfer Case Rear Output Shaft Bushing NOTE: Follow the steps below for use of the J-45380 remover/installer. Procedure Only remove the bushing if faulty. Refer to Transfer Case Rear Half Cleaning and Inspection . Install the finger section of the J-45380 remover/installer in front of the bushing. Install the tube and forcing screw assembly into the finger section. Ensure the forcing screw is backed out. Using a wrench on the forcing screw, remove the bushing. Special Tools J-45380 Transfer Case Rear Bushing Remover and Installer

Callout

Component Name

Transfer Case Rear Output Shaft Seal

CAUTION: Refer to Transfer Case Seal Removal Caution .

Transfer Case Rear Output Shaft Bushing

NOTE: Follow the steps below for use of the J-45380 remover/installer.

Procedure

Only remove the bushing if faulty. Refer to Transfer Case Rear Half Cleaning and Inspection .
Install the finger section of the J-45380 remover/installer in front of the bushing.
Install the tube and forcing screw assembly into the finger section. Ensure the forcing screw is backed out.
Using a wrench on the forcing screw, remove the bushing.

Special Tools
J-45380 Transfer Case Rear Bushing Remover and Installer