Input Shaft Oil Seal Removal

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Illustrating Proper Input Shaft Oil Seal

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Input Shaft Oil Seal CAUTION: Refer to Machined Surface Damage Caution . Procedure Drill a pilot hole, as required, and insert a self-tapping screw into the body of the seal. Use a plier or slide hammer type tool to remove the seal from the bore.