LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Transfer Case - Mp 3010 (NP0)) >> Diagnostic Information And Procedures >> Transfer Case Shift Control Switch Indicator Inoperative - One Or More >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. With in ignition off disconnect connector X1 at the transfer case control module and turn the ignition on. With a jumper wire probe the indicator control circuit of the affected indicator and take the other end of the jumper to ground. If the indicator comes on then replace the transfer case control module, program, and perform the motor learn procedure
  2. If the affected indicator did not come on then check the indicator control circuit for an open or high resistance. If the circuit checks good then replace the transfer case shift control switch.
scientia non olet · About LEMON Manuals