LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Transfer Case - Mp 3010 (NP0)) >> Diagnostic Information And Procedures >> Transfer Case Shift Control Switch Indicator Always On - Two Or More >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. With in ignition off disconnect connector X1 at the transfer case control module and turn the ignition on. If the affected indicator goes out replace the transfer case control module, program, and perform the motor learn procedure.
  2. If the affected indicator did not go out check for a short to ground on the affected indicator control circuit. If this checks as good then replace the transfer case shift control switch.
scientia non olet · About LEMON Manuals