LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Controls And Fuel - 6.0L (L96) - DTC P0351 To DTC P2636 And Diagnostic Information And Procedures) >> Diagnostic Information And Procedures >> DTC P1516, P2101, P2119 Or P2176: Throttle Actuator/Throttle Position >> Repair Verification

Repair Verification

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install any components that have been removed or replaced during diagnosis.
  2. Perform any adjustments, programming or setup procedures that are required when a component is removed or replaced.
  3. Clear the DTCs with a scan tool.
  4. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down.
  5. Ignition ON.
  6. Verify the scan tool TAC Motor parameter displays Enabled while performing the Throttle Sweep Test with a scan tool.
    • If Enabled is not displayed 

      Test or replace the Q38 Throttle Body.

    • Go to next step: If Enabled is displayed 
  7. If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not set.
    • Go to next step: If DTC does not set 
  8. All OK.
scientia non olet · About LEMON Manuals