LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Controls And Fuel - 6.0L (L96) - DTC P0351 To DTC P2636 And Diagnostic Information And Procedures) >> Diagnostic Information And Procedures >> DTC P0685, P0686, P0687, P0689, P0690 Or P1682: Engine Controls Ignition Relay/Ignition 1 Switch Circuit 2 >> Component Testing >> Relay Test

Relay Test

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Remove the component: KR75 Engine Controls Ignition Relay
  3. Test for 70 to 110 ohms between the test points: Component terminal 85 & 86
    • If not between 70 and 110 ohms 

      Replace the component: KR75 Engine Controls Ignition Relay

    • Go to next step: If between 70 and 110 ohms 
  4. Test for infinite resistance between the test points:
    • Component terminal 30 & 85
    • Component terminal 30 & 86
    • Component terminal 30 & 87
    • Component terminal 85 & 87
    • If less than infinite resistance 

      Replace the component: KR75 Engine Controls Ignition Relay

    • Go to next step: If infinite resistance 
  5. Connect a 3 A fused jumper wire between the test points: Component terminal 86 & B+

    Connect a jumper wire between the test points: Component terminal 85 & Ground

  6. Test for less than 2 ohms between the test points: Component terminal 30 & 87
    • If 2 ohms or greater 

      Replace the component: KR75 Engine Controls Ignition Relay

    • Go to next step: If less than 2 ohms 
  7. All OK.
scientia non olet · About LEMON Manuals