With Scan Tool
- Ignition - On / Vehicle - In Service Mode
- Select:Module Diagnostics
- Select:Engine Control Module
- Select:Configuration/Reset Functions
- Select:Learn Functions
- Select:Idle Learn
- Follow the instructions on the scan tool.
- Verify the scan tool parameter:Throttle Body Idle Air Flow Compensation = 0 %
- If greater than 0
Repeat step 1
- Go to next step: If 0
- If greater than 0
- Engine - Idling - At normal operating temperature
- Verify the scan tool parameter:Engine Speed= - 100 to + 200 RPM of the Desired Idle Speed
- {Test failed 1 time(s)} If not in the specified range
- Engine idling. - For greater than 3 min
- Ignition/Vehicle - Off - For greater than 1 min
- Engine idling. - For greater than 3 min
- Repeat step 9
- {Test failed 2 time(s)} If not in the specified range
- Perform the following action:Road test the vehicle.
- Vehicle Speed - Greater than 70 km (44 mi)
- Decelerate - For 2 s
- Repeat step 10.2 - 3 times
- Engine idling. - For greater than 3 min
- Repeat step 9
- {Test failed 3 time(s)} If not in the specified range
Refer to:Diagnostic System Check - Vehicle
- Go to next step: If in the specified range
- All OK.