LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 5.3L (L83) Or 6.2L (L86) - Repair Instructions >> Repair Instructions >> Evaporative Emission Canister Solenoid Replacement >> Removal Procedure

Removal Procedure

NOTE:

Clean the evaporative emission (EVAP) connections and surrounding areas prior to disconnecting the fittings in order to avoid possible system contamination.

  1. Remove the spare tire and wheel assembly.
    2. Fig 1: View Of EVAP Canister Vent Solenoid Electrical Connector
    GM1706529Courtesy of GENERAL MOTORS COMPANY
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Disconnect the chassis wiring harness electrical connector from the EVAP canister vent solenoid.
    4. Fig 2: EVAP Canister Vent Solenoid Quick Connect Fitting
    GM2759395Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the EVAP canister vent solenoid quick connect fitting (1) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: Push Pin
    GM3637954Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the solenoid vent filter from the filler pipe by removing the push pin (1).
    6. Fig 4: 2 Tie Straps
    GM2759398Courtesy of GENERAL MOTORS COMPANY
  6. Remove the 2 tie straps (1) that hold the solenoid vent line to the fuel fill pipe hose.
    7. Fig 5: EVAP Canister Vent Solenoid Retainer
    GM2759400Courtesy of GENERAL MOTORS COMPANY
  7. Disengage the retainer (1) securing the EVAP canister vent solenoid to the bracket.
  8. Remove the EVAP canister vent solenoid assembly.
scientia non olet · About LEMON Manuals