Front Axle Lubricant Level Inspection (9.25 Inch HD Axle)
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Make sure the vehicle is level.
- Inspect the front axle for leaks. Repair as necessary.
- Clean the area around the front axle fill plug.
- Remove the front axle fill plug (1).
- Inspect the oil level.
Specification
The 9.25 inch axle the oil level should be between 0 - 6 mm (0 - 0.25 in) below the fill plug opening.
- If the level is low, add oil until the level is between 0 - 6 mm (0 - 0.25 in) for the 9.25 inch axle. Use the correct fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the fill plug and tighten to 33 N.m (24 lb ft).
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .