Front Axle Lubricant Level Inspection (8.25 Inch LD Axle)
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Make sure the vehicle is level.
- Inspect the front axle for leaks. Repair as necessary.
- Clean the area around the front axle fill plug.
- Remove the front axle fill plug (1).
- Inspect the oil level.
Specification
The oil level should be between 12 - 16 mm (0.50 - 0.625 in) below the fill plug opening.
- If the level is low, add oil until the level is between 12 - 16 mm (0.50 - 0.625 in). Use the correct fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the fill plug and tighten to 33 N.m (24 lb ft).
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .