Front Seat Cushion Outer Finish Cover Replacement (8-Way Power)

Fig 1: Front Seat Cushion Outer Finish Cover (8-Way Power)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the seat belt from the front seat belt anchor plate tensioner. Refer to Front Seat Belt Anchor Plate Tensioner Replacement
1	Front Seat Cushion Outer Finish Cover Front Fastener CAUTION: Refer to Fastener Caution .
2	Front Seat Cushion Outer Finish Cover Rear Fastener CAUTION: Refer to Fastener Caution .
3	Front Seat Cushion Outer Finish Cover Procedure Disengage the seat back cushion finish panel straps and pull back the toe kick cover to gain access to the rear fastener. Remove the outer finish cover by pulling upward near the retainer clip locations. Disconnect the electrical connectors. If replacing the finish cover, transfer components as necessary.