Rear Side Door Trim Replacement (Cadillac)

Fig 1: Rear Side Door Trim (Cadillac)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Rear Side Door Inside Handle Bolt Finish Cap NOTE: Use a suitable tool, place the tool between the notch located at the rear of the door handle cap and the door handle. Turn the suitable tool clockwise releasing the door handle cap, exposing the handle fastener.
2	Rear Side Door Inside Handle Fastener CAUTION: Refer to Fastener Caution . Tighten 1.4 N.m (12 lb in)
3	Rear Side Door Armrest Pull Cup Bolt Cap
4	Rear Side Door Armrest Pull Cup Fastener (Qty: 2) Tighten 2.5 N.m (22 lb in)
5	Rear Side Door Trim Panel Fastener Tighten 2.5 N.m (22 lb in)
6	Rear Side Door Trim Panel Assembly Procedure Use the appropriate plastic trim tool to aid in the removal of the door trim. Remove the door trim panel by pulling outward at the top of the trim panel to disengage the upper retainers. Replace the door trim retainers as needed. Disconnect the door lock retainer cable from the door trim panel and the inside handle. Unclip the harness retainers from the door trim. Disconnect the electrical connectors.