Installation Procedure
- Install the transmission range selector lever cable in the vehicle.
- Install the grommet and cable assembly into the floor panel with alignment key opening.
Install the cable to the transmission control, then slide the transmission range selector lever cable retainer (1) forward to lock the transmission range selector cable to the transmission control base.
- Connect the transmission range selector lever cable terminal (2) to the shift lever pin.
- Install the transmission control bolt to retain the cable retainer then tighten the bolt to 9 N.m (80 lb in).
- Front Floor Lower Console Replacement - Install
-
Courtesy of GENERAL MOTORS COMPANY
WARNING:After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.
Connect the transmission range selector lever cable terminal (1) to the transmission manual shift lever pin (6).
- Install the cable into the bracket and ensure cable is fully seated.
Install the cable retainer (2), then the cable retainer bolt (1) and tighten the bolt to 9 N.m (80 lb in)
- Adjust the cable. Range Selector Lever Cable Adjustment .
- {If equipped} Transmission Heat Shield - Install - Transmission Heat Shield Replacement
Ensure the grommet is properly oriented.
After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.
Refer to Fastener Caution .
A second generation range selector lever cable has a retaining bracket, the lower front transmission control retaining bolt will need to be installed to retain the cable.