LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> CTS Base, RWD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 2.0L (LTG) - Repair Instructions >> Repair Instructions >> Charge Air Cooler Inlet Air Tube Replacement >> Installation Procedure

Installation Procedure

  1. GM2873828Courtesy of GENERAL MOTORS COMPANY

    Install the charge air cooler inlet air tube (2) to the vehicle.

  2. Connect the charge air cooler inlet air tube (2) to the charge air cooler and engage the retaining clip (1).
  3. Install the charge air cooler inlet air tube to the turbocharger.
  4. Raise the vehicle.
  5. GM2873830Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Install the charge air cooler inlet air tube bolts (1) to the charge air cooler inlet air tube (2) and tighten to 10 N.m (89 lb in).

  6. Install the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (CTS) .
  7. Install the front compartment lower noise shield. Refer to Front Compartment Lower Noise Shield Replacement (AWD)Front Compartment Lower Noise Shield Replacement (RWD) .
  8. Lower the vehicle.
  9. Install the clamp and connect the charge air cooler inlet air tube to the inlet air hose.
  10. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals