|
Preliminary Procedures
- Remove the front compartment front sight shield. Refer to Front Compartment Front Sight Shield Replacement (CTS)Front Compartment Front Sight Shield Replacement (CTS-V)
.
- Remove the front wheelhouse liners. Refer to Front Wheelhouse Liner Replacement (CTS)Front Wheelhouse Liner Replacement (CTS-V)
.
- Remove the front bumper fascia air deflector center. Refer to Front Bumper Fascia Air Deflector Replacement - Center Front Bumper Fascia Air Deflector Replacement - Center (CTS-V) .
|
| 1 |
Front Bumper Fascia Reinforcement Bolt (Qty: 2)
Tighten
4 N.m (35 lb in) |
| 2 |
Front Bumper Fascia Reinforcement (Qty 2) |
| 3 |
Front Bumper Fascia Upper Bolt (Qty: 8)
Tighten
4 N.m (35 lb in) |
| 4 |
Front Bumper Fascia Outer Bracket Bolt (Qty: 4)
Tighten
9 N.m (80 lb in) |
| 5 |
Front Bumper Fascia Procedure
- Carefully push a small nylon wedge between the fascia and the headlamp bracket. Insert a small flat-bladed tool into the fascia slot and depress the snaps (2 on each side) one at a time and pull on the fascia at the same time to gradually remove the fascia from the headlamp bracket.
- Disconnect any electrical connectors.
- Transfer components as necessary.
|