LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> XTS Livery >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 3.6L (LFX LF3) - Repair Instructions >> Repair Instructions >> Fuel Injection Fuel Rail Assembly Replacement - Bank 1 (LFX) >> Installation Procedure

Installation Procedure

    Fig 1: Sliding Fuel Rail Toward Front Of Engine
    GM2497938Courtesy of GENERAL MOTORS COMPANY
  1. Slide the fuel rail (1) toward the front of the engine approximately 1 inch (25.4mm), in order to align the center injector bore.
    2. Fig 2: Identifying Fuel Rail Bolt Tightening Sequence
    GM2193072Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Hand tighten the two outer fuel rail fasteners to seat the injectors.
  3. Start and hand tighten the remaining fuel rail fasteners.
  4. Tighten the fuel rail fasteners in the sequence shown above to 23 N.m (17 lb ft).
  5. Install the fuel feed intermediate pipe. Fuel Feed Intermediate Pipe Replacement (LFX) 
  6. Inspect for fuel leaks using the following procedure:
    1. Turn ON the ignition, with the engine OFF for 2 seconds.
    2. Turn OFF the ignition, for 10 seconds.
    3. Turn ON the ignition, with the engine OFF.
    4. Inspect for fuel leaks.
  7. Install the fuel injection fuel rail noise shield to the fuel rails.
  8. Install the intake manifold. Intake Manifold Replacement (LFX)Intake Manifold Replacement (LF3)
  9. Install the fuel pipe shield. Fuel Pipe Shield Replacement (LFX) 
  10. Install the low side fuel pressure service port cap.
  11. Install the fuel tank cap.
scientia non olet · About LEMON Manuals