Rocker Panel Molding Replacement

Fig 1: Rocker Panel Molding & Screws

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Open both front and rear side doors.
1	Rear Wheelhouse Panel Liner Screw (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Front Wheelhouse Front Liner Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
3	Rocker Panel Molding Procedure Release the 2 rocker panel molding retainers from the front fender. Release the 2 rocker panel molding retainers from the body side outer panel. From the bottom edge firmly pull down the rocker panel molding (6 retainers) from the body side outer panel reinforcement. From the top edge firmly pull out the rocker panel molding (11 retainers) from the body side outer panel and remove from the vehicle.