Front Fender Upper Rear Molding Replacement

Fig 1: Front Fender Upper Rear Molding

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Open front side door.
1	Front Fender Upper Rear Molding Procedure Using a suitable trim release tool, release the bottom spring clip and then release the top 2 retainers from the front fender. Upon reinstallation, using the palm of the hand secure each retainer location until fully seated.

Callout

Component Name

Preliminary Procedure
Open front side door.

Front Fender Upper Rear Molding

Procedure

Using a suitable trim release tool, release the bottom spring clip and then release the top 2 retainers from the front fender.
Upon reinstallation, using the palm of the hand secure each retainer location until fully seated.