LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> XTS Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T70 (M7U M7W), 6T75 (M7V), Or 6T80 (Mhm) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement (AWD) >> Installation Procedure

Installation Procedure

  1. Position the transmission bracket to the transmission.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transfer case bracket bolts and tighten to 100 N.m (74 lb ft).
    3. Fig 1: Transaxle Mount Components
    GM2201655Courtesy of GENERAL MOTORS COMPANY
  3. Install the transmission mount (2) to the frame.
  4. Install the longer transmission mount to frame bolt (3) and tighten to 62 N.m (46 lb ft).
  5. Install the shorter transmission mount to frame bolts (4) and tighten to 100 N.m (74 lb ft).
  6. Install the through bolt (1) and tighten to 100 N.m (74 lb ft).
  7. Remove the support from the transaxle.
  8. Install the battery tray. Battery Tray Replacement
  9. Install the steering gear heat shield. Steering Gear Heat Shield Replacement (NXC)Steering Gear Heat Shield Replacement (NJ2)
  10. Install the steering gear. Steering Gear Replacement (AWD, LFX, NXC)Steering Gear Replacement (AWD, LF3, NXC)
  11. Install the propeller shaft. Refer to Propeller Shaft Replacement
  12. Install the front exhaust pipe. Exhaust Front Pipe Replacement (LF3)Exhaust Front Pipe Replacement (AWD)
  13. Lower the vehicle.
scientia non olet · About LEMON Manuals