Case Cover Assembly Installation

Fig 1: Case Cover Assembly And Bolt Tightening Sequence

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Input Shaft Thrust Bearing NOTE: Note location of the orientation lip on bearing. All thrust bearings can only be assembled one way.
2	A/Trans Case Cover Gasket
3	Input Speed Sensor Wire Harness NOTE: Route the input speed sensor wire harness through the case passage.
4	A/Trans Case Cover Assembly Procedure Use guide pins to install the case cover assembly to prevent damage to the input shaft thrust bearing. Pull the input speed sensor wire harness through the case passage while lowering the cover assembly onto the case. Special Tools 39068 Guide Pins For equivalent regional tools, refer to Special Tools .
5	A/Trans Case Cover Assembly Bolt M6 x 30 (Qty: 10) CAUTION: Refer to Fastener Caution . Procedure Tighten in sequence shown. Tighten 12 N.m (106 lb in)