Component Testing
Tap Shift Switch Resistance
| Switch | Switch State | Switch Terminals | Resistance |
|---|---|---|---|
| S2L Transmission Manual Shift Switch - Left | Open | 1 - 2 | 5206 - 5754 Ω |
| S2L Transmission Manual Shift Switch - Left | Closed | 1 - 2 | 1300 - 1440 Ω |
| S2R Transmission Manual Shift Switch - Right | Open | 1 - 2 | ∞ Ω |
| S2R Transmission Manual Shift Switch - Right | Closed | 1 - 2 | 606 - 670 Ω |
| S2R Transmission Manual Shift Switch - Right | Open | 1 - 3 | 598 - 662 Ω |
| S2R Transmission Manual Shift Switch - Right | Closed | 1 - 3 | 598 - 662 Ω |
| S2R Transmission Manual Shift Switch - Right | Open | 2 - 3 | ∞ Ω |
| S2R Transmission Manual Shift Switch - Right | Closed | 2 - 3 | Less than 5 Ω |
Static Test
- Ignition OFF, disconnect the harness connector from the S2L Transmission Manual Shift Switch - Left and S2R Transmission Manual Shift Switch - Right.
- Test the resistance between the switch terminals and verify the resistance is within the specified value listed in the above table.
- If the resistance is not within the specified range
Replace the affected switch.
- If the resistance is within the specified range
- If the resistance is not within the specified range
- All OK.