Circuit/System Testing
- Observe the Freeze Frame/Failure Records with a scan tool.
- Clear the DTCs with a scan tool.
- Ignition OFF for 30 s.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
- Verify the DTCs P0658 or P0659 are not set.
- If the DTCs P0658 or P0659 are set
Replace the K20 Engine Control Module
- If yhe DTCs P0658 or P0659 are not set
- If the DTCs P0658 or P0659 are set
- All OK.