LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> XT5 Base >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Rear Bumper Fascia Replacement

Rear Bumper Fascia Replacement

Fig 1: Rear Bumper Fascia
GM4295690Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Rear Wheel Opening Molding Replacement
  2. Rear Wheelhouse Liner Replacement
1 Rear Bumper Fascia Pad Bolt Cap (Qty: 2)
2 Rear Bumper Fascia Bolt (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
2.5 N.m (22 lb in)
3 Rear Bumper Fascia Outer Corner Reinforcement Bolt (Qty: 2)
Tighten 
2.5 N.m (22 lb in)
4 Liftgate Bumper Pad Bolt (Qty: 2)
Tighten 
2.5 N.m (22 lb in)
5 Rear Bumper Fascia

Procedure

  1. Carefully push a small nylon wedge between the fascia and the rear fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the rear fascia guide.
  2. Disconnect all electrical connectors.
  3. Transfer components as necessary.
scientia non olet · About LEMON Manuals