Stabilizer Shaft Insulator Replacement (Light Duty)

Fig 1: Stabilizer Shaft Insulator (Light Duty)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove Steering Gear Skid Shield. Refer to Steering Gear Skid Shield Replacement
1	Front Stabilizer Shaft Clamp Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 50 N.m (37 lb ft)
2	Front Stabilizer Shaft Clamp
3	Front Stabilizer Shaft Insulator NOTE: Ensure the slit in the front stabilizer shaft insulator is facing toward the front of the vehicle when installed.