Rear Output Shaft Seal Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Rear Output Shaft Seal

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement (1500)Rear Propeller Shaft Replacement (Heavy Duty) .
1	Transfer Case Output Shaft Seal Procedure Remove the seal using a flat-bladed tool. Install the seal with the notch at the top and the weep hole at the bottom. NOTE: Use the appropriate seal installer depending on application. Special Tools DT-48021 Seal Installer (Heavy Duty) DT-48210 Seal Installer (Light Duty) GE-8092 Driver Handle For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Transfer Case Output Shaft Seal

Procedure

NOTE:

Use the appropriate seal installer depending on application.

Special Tools

For equivalent regional tools, refer to Special Tools .