Noise and Vibration Analysis
WARNING: This page is about a different car, the 2017 GMC Yukon XL, 2017 GMC Yukon, 2017 Chevrolet Tahoe, 2017 Chevrolet Suburban 3500 HD, and 2017 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following is only a general noise and vibration analysis. For more detailed and vehicle specific noise and vibration analysis, refer to the latest published Preliminary Information documents and Field Service Bulletins available in eSI.
A noise or vibration that is noticeable when the vehicle is in motion MAY NOT be the result of the transmission.
If noise or vibration is noticeable in PARK and NEUTRAL with the engine at idle, but is less noticeable as RPM increases, the cause may be from poor engine performance.
- Vibration may also be caused by a small amount of water inside the converter.
- Inspect the tires for the following conditions:
- Uneven wear
- Imbalance
- Mixed sizes
- Mixed radial and bias ply
- Inspect the suspension components for the following conditions:
- Alignment wear or damage
- Loose fasteners
- Driveline damage or wear
- Inspect the engine and transmission mounts for damage and loose bolts.
- Inspect the transmission case mounting holes for the following conditions:
- Missing bolts, nuts, and studs
- Stripped threads
- Cracks
- Inspect the flywheel for the following conditions:
- Missing or loose bolts
- Cracks
- Imbalance
- Inspect the torque converter for the following conditions:
- Missing or loose bolts or lugs
- Missing or loose balance weights
- Imbalance caused by heat distortion or fluid contamination