LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> Escalade ESV Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Automatic Transmission - 6L80 (MYC) Or 6L90 (MYD) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0973 or P0974: Shift Solenoid Valve 1 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 GMC Yukon XL, 2017 GMC Yukon, 2017 Chevrolet Tahoe, 2017 Chevrolet Suburban 3500 HD, and 2017 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Engine Running, place the gear selector in Reverse for 5 seconds and then idle the vehicle in Park for 5 seconds.
  2. Verify the scan tool parameters listed below do not display Malfunction:
    • Shift Solenoid Valve 1 Control Circuit High Voltage Test Status
    • Shift Solenoid Valve 1 Control Circuit Open Test Status
    • Shift Solenoid Valve 1 Control Circuit Low Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing.

    • If Malfunction is not displayed 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observe from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  5. All OK.
scientia non olet · About LEMON Manuals