LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> Escalade ESV Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Automatic Transmission - 6L80 (MYC) Or 6L90 (MYD) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0756: Shift Solenoid Valve 2 Performance - Stuck Off >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 GMC Yukon XL, 2017 GMC Yukon, 2017 Chevrolet Tahoe, 2017 Chevrolet Suburban 3500 HD, and 2017 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    If other DTCs are set, diagnose those DTCs first.

  1. Engine idling in Park position, with parking brake applied and drive wheels chocked.
  2. Verify the transmission fluid level and condition is correct. Refer to Transmission Fluid Level and Condition Check .
    • If the transmission fluid level and condition is not correct 

      Repair as necessary.

    • If the transmission fluid level and condition is correct 
  3. Ignition ON, clear the Transmission Control Module DTCs with a scan tool.
    4. NOTE:

    During the road test, the Transmission Control Module has to see 3 attempts at a 1 through 6 gear shift change.

  4. Verify the transmission operation performs as indicated in the road test instructions and DTC P0756 did not set. Refer to Road Test .
    • If DTC P0756 is set 

      Refer to Circuit/System Testing.

    • If DTC P0756 did not set 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observe from the Freeze Frame/Failure Records data.
  6. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals