LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> Escalade ESV Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Right Side (Two Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount
    GM1701802Courtesy of GENERAL MOTORS COMPANY
  1. Position the engine mount to the engine.
    2. Fig 2: View Of Engine Mount To Engine Bolts
    GM1701534Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the engine mount to engine bolts (1) and tighten to 50 N.m (37 lb ft).
  3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
  4. Partially lower the vehicle.
    5. Fig 3: View Of Engine Mount To Frame Bolts
    GM1701531Courtesy of GENERAL MOTORS COMPANY
  5. Install the engine mount to frame bolts (1). Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.
  6. Install the right wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side (Chevrolet) .
  7. Raise the vehicle.
  8. Install the front stabilizer shaft insulators. Refer to Stabilizer Shaft Insulator Replacement (Heavy Duty) .
  9. Install the clip for the transmission cooler lines.
  10. Lower the vehicle.
  11. Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals