LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> Escalade ESV Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Left Side (Four Wheel Drive) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

When raising or supporting the engine for any reason, do not use a jack under any sheet metal or the crankshaft pulley.

  1. Remove Upper Intake Manifold Sight Shield Upper Intake Manifold Sight Shield Replacement 
  2. Partially raise the vehicle. Lifting and Jacking the Vehicle
  3. Remove Front Wheelhouse Liner-Left Side Front Wheelhouse Liner Replacement - Left Side (Chevrolet)
    4. Fig 1: View Of Engine Mount To Frame Bolts
    GM1701017Courtesy of GENERAL MOTORS COMPANY
  4. Remove Engine Mount Bolt (1).
  5. Remove Intermediate Steering Shaft Intermediate Steering Shaft Replacement
  6. Remove Exhaust Manifold Heat Shield-Left Side Exhaust Manifold Heat Shield Replacement - Left Side (L96)
  7. Install Underbody Skid Shield Underbody Skid Shield Replacement
  8. Position a screw jack and a block of wood under the engine oil pan.
    9. Fig 2: View Of Engine Mount To Engine Bolts
    GM1701533Courtesy of GENERAL MOTORS COMPANY
  9. Remove Engine Mount Bolt (1)
  10. Using the adjustable jack, raise the engine slightly until there is enough clearance to remove the engine mount.
    11. Fig 3: Engine Mount
    GM4328743Courtesy of GENERAL MOTORS COMPANY
  11. Remove Engine Mount (1)
scientia non olet · About LEMON Manuals