LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> Escalade ESV Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Left Side (Four Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount
    GM4328743Courtesy of GENERAL MOTORS COMPANY
  1. Install Engine Mount (1)
    2. Fig 2: View Of Engine Mount To Engine Bolts
    GM1701533Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install Engine Mount Bolt (1)
  3. Install Engine Mount Bolt - Tighten 50 N.m (37 lb ft)
  4. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
  5. Remove the adjustable jack and block of wood from the engine oil pan.
  6. Install Underbody Skid Shield Underbody Skid Shield Replacement
  7. Install Exhaust Manifold Heat Shield-Left Side Exhaust Manifold Heat Shield Replacement - Left Side (L96)
  8. Install Intermediate Steering Shaft Intermediate Steering Shaft Replacement
  9. Partially lower the vehicle.
    10. Fig 3: View Of Engine Mount To Frame Bolts
    GM1701017Courtesy of GENERAL MOTORS COMPANY
  10. Install Engine Mount Bolt (1)
  11. Engine Mount Bolt (1) - Tighten 65 N.m (48 lb ft)
  12. Install Front Wheelhouse Liner-Left Side Front Wheelhouse Liner Replacement - Left Side (Chevrolet)
  13. Lower the vehicle.
  14. Upper Intake Manifold Sight Shield Upper Intake Manifold Sight Shield Replacement 
scientia non olet · About LEMON Manuals