LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> Escalade ESV Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Idler Pulley
    GM678804Courtesy of GENERAL MOTORS COMPANY
  1. Position the drive belt idler pulley to the generator bracket and tighten the idler pulley bolt finger tight.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Tighten the drive belt idler pulley bolt.

    Tighten 

    Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals