LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> Escalade ESV Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Air Conditioning Compressor Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove Drive Belt Drive Belt Replacement - Accessory 
  2. Remove Steering Gear Skid Shield Steering Gear Skid Shield Replacement
    3. Fig 1: Webbing
    GM4604111Courtesy of GENERAL MOTORS COMPANY
  3. Insert the EN-51767-5  Webbing (1) between the pulley (2) and belt (3).
  4. While walking the EN-51767-5  Webbing around the circumference of the pulley, rotate the crankshaft pulley counterclockwise.
  5. Once the EN-51767-5  Webbing is around the circumference of the crankshaft pulley, pull the loose end of the EN-51767-5  Webbing inward toward the engine, removing the belt from the crankshaft pulley.
  6. Remove the belt from the air conditioning compressor pulley and then from the vehicle.
scientia non olet · About LEMON Manuals