LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> Escalade ESV Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Mechanical - 6.0L (L96)) >> Diagnostic Information and Procedures >> Cylinder Deactivation (Active Fuel Management) System Diagnosis

Cylinder Deactivation (Active Fuel Management) System Diagnosis

WARNING: This page is about a different car, the 2017 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT:

    Cylinder Deactivation (Active Fuel Management) System Diagnosis is applicable for RPO LH6/LMG/LY5/LC9/L76.

  1. Measure the engine oil level. Fill, as required.
  2. Using the scan tool, inspect for diagnostic codes within the engine control module (ECM). Refer to Diagnostic System Check - Vehicle . Repair, as required.
  3. Verify proper engine oil pressure and operation of the active fuel management oil pressure relief valve. Refer to Oil Pressure Diagnosis and Testing .
  4. Verify proper operation of the active fuel management system components. Refer to Cylinder Deactivation (Active Fuel Management) System Compression Test .
  5. Remove the valve lifter oil manifold. Refer to Valve Lifter Oil Manifold Replacement .
  6. Verify proper operation of the valve lifter oil manifold. Refer to Cylinder Deactivation (Active Fuel Management) Valve Lifter Oil Manifold Diagnosis and Testing .
  7. Replace the active fuel management valve lifters, as required. Both intake and exhaust lifters should be replaced in pairs. Refer to Valve Lifter Replacement .
scientia non olet · About LEMON Manuals