Vehicle Speed Sensor Replacement

WARNING: This page is about a different car, the 2017 GMC Yukon XL, 2017 GMC Yukon, 2017 Chevrolet Tahoe, and 2017 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Vehicle Speed Sensor & O-Ring

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
1	Vehicle Speed Sensor CAUTION: Refer to Component Fastener Tightening Caution . Procedure Disconnect vehicle speed sensor electrical connector. Tighten 17 N.m (13 lb ft)
2	Vehicle Speed Sensor O-Ring Procedure Lightly lubricate the O-ring with clean transfer case fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers .

Callout

Component Name

Preliminary Procedures

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .

Vehicle Speed Sensor

CAUTION:

Refer to Component Fastener Tightening Caution .

Procedure
Disconnect vehicle speed sensor electrical connector.
Tighten
17 N.m (13 lb ft)

Vehicle Speed Sensor O-Ring
Procedure
Lightly lubricate the O-ring with clean transfer case fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers .