Transfer Case Two/Four Wheel Drive Actuator Replacement

WARNING: This page is about a different car, the 2017 GMC Yukon XL, 2017 GMC Yukon, 2017 Chevrolet Tahoe, and 2017 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transfer Case Two/Four Wheel Drive Actuator

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1	Two/Four Wheel Drive Actuator Bolt (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 18 N.m (13 lb ft)
2	Two/Four Wheel Drive Actuator Procedure Disconnect the electrical connector.
3	Two/Four Wheel Drive Actuator Seal Procedure Use J-45278 seal remover and J-23907 slide hammer to remove the seal from the actuator. Use the J-44907 bearing installer to install the seal to the actuator. NOTE: Remove the seal from the actuator ONLY if seal replacement is necessary. Special Tools J-23907 Slide Hammer J-44907 Bearing Installer J-45278 Seal Remover For equivalent regional tools, refer to Special Tools .